Z34 370z high tensile offset steering rack conversion extenders

Z34 370z high tensile offset steering rack conversion extendersThe GKTECH high tensile offset steering rack conversion extenders offer 3 primary benefits; offset rack spacer moving the rack forward to eliminate steering bind on high lock setups, unique to our design these convert the tie rod thread from the uncommon M18 to a much more common M16 and they offer more steering rack travel which in turn gives more steering lock. Offset rack spacers are a great alternative to moving the steering rack forward.

Looking for a dependable and high-quality master cylinder for your motorsport or custom application

5 +22 Enkei RPF1 wheel was tested and still has around 5 mm of clearance (ample)

- Fits the Gktech Z33 350z/ Z34 370z Crossmember with slight shaving to one side

5" pipe and includes the 2x custom bends to run through the factory radiator support (without the need for cutting)

Over time your handbrake cables have probably streched to the point that your handbrake can barely lock up

These are CNC machined from 6061-T6 aluminium and are sold as a set of 4

Alternatively

CNC mandrel bent arms (toe arms

- Made specifically for use on Z34 370z's or V36 Skylines but may also fit other vehicles

If you don't want to waste time shopping around for all the individual parts

Replacement PCYML10TS tie rod end bearing Used in the following GKTECH products:

The GKTech 350z/V35 Skyline Rear toe arms give you the ability to adjust and tune your vehicle's rear toe