Z33 350Z W underbody brace

Z33 350Z W underbody braceAs with almost all products we design, they're made from actual need from our own personal experience. The OEM Nissan W brace is a sturdy unit but over time they cop a beating and they are very expensive to replace. We have designed a direct replacement of the OEM unit that is strong but also lightweight by using a combination of multiple sheets with inner uprights and dimple dies throughout. Laser cut using multiple 2. 0mm 4130 steel sheets, dimple

The OEM rubber bushes are prone to high loads

Circa 60+ degrees of lock is achievable without offset rack spacers once the factory LCA lock stop is removed but if you're running lots of camber or caster using our offset rack spacers is a good idea to avoid steering bind

SKU - Z34X-PGBM - Seen HERE

- CNC Laser cut high strength steel with CNC machined ends

- Manufactured from 4130 chromoly tube with billet CNC machined ends and CNC machined 4130 chromoly adjusters

(SOLD SEPARATELY)

Roll center correction kit tie rod end bolt conversion kit replaces the shank

The V2 GKTECH Z33 350Z/Z34 370z gearbox cross member has been designed as a bolt on solution when fitting these gearboxes to an S chassis when running either an SR20/KA24 motor

The brake lines have been independently tested to comply with FMVSS106 standards for brake hoses

please ensure you have adequate clearance between the arm and the subframe

- 100mm PCD with M12 x 1

The GKTECH Solid Aluminium Steering Rack Bushes are a direct replacement of the OEM rubber bushes