Open Ended Lock Nuts (Set of 4 + Socket)

Open Ended Lock Nuts (Set of 4 + Socket)Steel slimline open ended lock nuts to suit aftermarket rims (60 taper) Specs: Available in either M12x1. 25 or M12x1. 5 thread 55mm's in length 60 taper to suit aftermarket rims (will NOT seat properly with standard rims) Lock nut hex head Manufactured from steel (not aluminium that will strip) Sold as a set of 4 lock nuts + socket to suit

The GKTECH high tensile 4130 zinc coated tie rod extenders screw on to the end of either standard or aftermarket tie rods and allow the tie rods to travel further into the steering rack which creates more steering lock

This listing is for a replacement gasket for the OEM intake manifold gasket on the VQ35DE found in the Nissan Z33 350z/ V35 OEM Part number -14033-AM600

NOTE: if fitting to a V36 fitted with a VQ35HR then you will need to make your own PCV solution as the VQ37 setup does differ

The brake lines have been independently tested to comply with FMVSS106 standards for brake hoses

The GKTECH gearbox lower shift boot is a replacement for the OEM boot and can be used with either the GKTECH short shifter or the OEM shifter across a large range of Nissan vehicles

meaning when adding 1x to the cart you will receive

- Available in both 12mm and 14mm (specify at the time of ordering)

air will get sucked into the intake after the air flow meter and the car will run very rough

The GKTECH Polyurethane gearbox mount is a direct replacement of the standard item and helps reduce engine and gearbox movement and get power to the ground

Rose joint to suit the following master cylinder:

Replacement HCOM24T bearing used in the Z34 370z item "Z34X-FBSH"/p>

We also include dust boots to protect the rose/ heim joints and have lock stops built into the arm for those that want to dial down the fun