Cable Guard

Cable GuardTrying to mount an external transducer on your trolling motor but worried about the expensive transducer cable getting into a bind and possibly breaking? If so, you need the Cable Guard! The coiled hose is split down one side allowing you to press the transducer cable into the hose. The hose is stretched between two aluminum brackets that are mounted to the shaft of the trolling motor. This model is intended for mounting 2D Down Imaging, and Side

A Falcon Console Mounting System Plate that comes with our Patented Smart Brackets and your choice of discs to match those units

If you are looking for a way to mount your LiveScope/ActiveTarget/MegaLive transducer without getting the transducer cable into a bind

Made from Acetal Co-polymer to fit with HDS G1/G2 Push Buttons units

Backer Plate required for $49

For Gen 3 and Carbon Units ONLY

A Ranger Z Series Bow Replacement Plate from the early 2000 models and fits all the way till today

Patented Smart Brackets that are roughly 3" tall

This is a popular upgrade for those that want to make it easier to view and adjust their units versus our regular sized Smart Brackets

Please note that this finish may slightly reduce the sharpness or clarity of the display image

Eliminates drilling holes in the deck and places the sensor/antenna where it will be most effective

A 23-in V shaped spreader bar that is a quarter inch thick aluminum and is built for stability and strength

Comes in six-hole pattern that fits well with our Patented Smart Brackets for your Bow or Console Mount