Coolant tube | 100µ Filter HSK 63

Coolant tube | 100µ Filter HSK 63Application: For the coolant supply through the centre of HSK toolholders. Note: With filter for dirt particle free cooling 100 stainless steel mesh filter According to DIN 69895 for HSK A and HSK E hollow taper shanks Axial sealed with two O rings Tightness of the screw connection tested up to 80 bar After mounting, the coolant tube can be moved only to a minimum degree according to DIN (1)

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance9

Magnifying glass is provided for easier reading

High holding forces: increase by a factor of 3 to 5 compared to standard jaws

For mounting tools with Morse taper shank and tang according to DIN 228-1 form B

For use in any tool holder Ø16mm with a center coolant

Mode : Peak

U/min: 3000

For mounting the coolant tubes in PSK toolholders

For mounting straight-shank tools

All collets with outside form DIN 6388 (ISO 10897) can be clamped

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

In this way the clamping ranges can be extended to smaller sizes