Cool-Aide (Internal Air Cooling)

Cool-Aide (Internal Air Cooling)This internal air cooler is a device that works on a standard compressed air supply and operates with the vortex principle. Compressed air enters the tube and is separated via a vortex into two parts, cold air exits on one end and hot air on the other. By hooking up the cold air end of the tube, cold air can be circulated inside a rotationally molded part to provide for more even cooling, inside and outside the part. These tubes are adjustable for

Mounting plate: 1500/220

Number of Molds Available: One 3-Mold Mount

This is the stainless steel version

Closures - Bolts and Receivers

Please note if Supacool is to be used against the line of draw a quick release procedure should be incorporated to facilitate mold servicing

large amounts of heat energy are absorbed dramatically reducing the inside temperature and the subsequent cooling times normally required

Advantages: Will not completely foul with plastic breathes through the entire heating and cooling cycle made of mineral wool excellent alternative to standard vent tubes

Supacool works with all your existing molds bolting easily onto the outside of the mold over an existing vent hole

The Supacool unit is easily bolted to the outside of the mold and fits inside a tube 280mm (11”) in diameter and 280mm (11”) long

Holding capacity of 1

see KC4010

Sealing kit - a set of seals and gaskets that needs to be replaced when opening the housing MPK1 pneumatic clamps for maintenance